Print this page

Clamp helps reduce distortion during welding process

  • font size decrease font size decrease font size increase font size increase font size

The Angle-Rite® clamping system from Meridian Stainless helps reduce shrinkage distortion that commonly occurs during tube and pipe welding. The system is designed to allow complete setup, cutting, and welding while the clamp is attached, so the angle and rotation of tube and pipe are maintained throughout the entire process.

The system comprises a primary clamp that prebends the intersected tube before welding. The secondary clamp holds the intersecting tube or pipe in a precise angle to be miter cut using the reciprocating saw attachment or notched using the abrasive or hole saw notcher. Following cutting, the secondary clamp holding its tube or pipe is rejoined with the primary clamp and its attached tube or pipe. The angle and rotational alignment of the tubes or pipes are retained throughout the entire process.

With the system clamping the primary and intersecting tube or pipe in place, the welder can weld the joint without requiring a third hand. The primary clamp’s bending force compensates for weld stress distortion during the welding process.

 

| Source: theFabricator  ||  October 25,  2017   |||