We just setup an 18 hour nylon print of 3 components on our Markforged X7 in #Auckland. One of them also has layers of continuous strand Kevlar to form a custom internal composite honeycomb panel. #Markforged #PrintStronger #3Dprinting #AdditiveManufacturing.
- Home
- News Sectors
- Headlines Through Today
- Environmental Talk
- Out of The Beehive
- Primary Sector Talk
- Reporters Desk
- The MSC NewsReel
- MSCNetwork
- FinTech Talk
- The FactoryFloor Newsreel
- Trade Talk
- News Talk
- Industry Talk
- Technology Talk
- Blockchain
- Highlighted
- The TravelDesk
- Travel Updates
- The MSC TravelDesk Newsreel
- Travel Talk
- Travel Time
- The Bottom Line
- Regional News
- News to Run Advice Form
- World News
- NewsDIRECT
- MSCVoxPops
- Press Releases
- National Press Club
- Contact Us
